Full Plumbing Refresh in Fort Worth - Hose Bibs, Tub Valve, and Faucet

This Fort Worth home had a few things going on at once - two leaking hose bibs outside, a worn-out tub and shower trim and valve, and an old lavatory faucet that needed to go. None of these are catastrophic on their own, but together they add up to real water waste and the kind of slow deterioration that tends to get worse the longer it sits.

The hose bibs were well past their useful life. Heavy corrosion, mineral buildup, and visible wear on the stems told the whole story. We pulled them both and put in new lead-free frost-free bibs that are built to hold up long-term. Clean shutoff, solid connection, no more dripping every time someone hooks up a hose.

Inside, we had the tub and shower valve to deal with. Our tech soldered in the new valve connection - torch work done right, with proper flux and solder to make sure that joint holds. Getting the valve depth and positioning dialed in before everything goes back together is the kind of detail that matters. A sloppy valve install can mean leaks inside the wall, which nobody wants to deal with later.

The lavatory faucet swap rounded out the job. New supply lines, a fresh p-trap, and a properly seated drain assembly - everything tight and leak-free before we packed up. When you're already on-site handling multiple fixtures, it makes sense to do it all at once rather than coming back for a second visit.

Small plumbing issues like these are easy to put off. But a dripping hose bib or a weeping faucet connection doesn't fix itself, and water damage has a way of quietly building behind walls and under cabinets. Getting ahead of it is always the smarter call.